+86-182-9191-0663 丨  sales@hiltechgroup.com | support@hiltechgroup.com
About Us

Since 1998 丨 HILTECH®

You are here: Home » Products » Control & Analysis Instrument » Gas Analysis Instrument » Laser Gas Analyzer

Laser Gas Analyzer

loading

Share to:
facebook sharing button
twitter sharing button
line sharing button
wechat sharing button
linkedin sharing button
pinterest sharing button
sharethis sharing button

• Communication port:RS232(default) or RS485

• Power supply:AC170 ~ 264V 50/60Hz

• Sample gas temperature:-10 ~ +50℃

• Sampling mode:sample gas pass-in

• Sample gas flow:300 ~ 600ml/min

 Sample gas pressure:0.05MPa≤entrance pressure≤0.35MPa,steady pressure environment

• Background gas:N2 and inactive gas

• Appearance Size:155mm×155mm×290mm(H×W×D)

 Install Hole Cut:135mm×135mm(H×W)

• Serving life:Type C>5 years;Type D>3 years(under normal use)

• Gas circuit port:NPT 1/8 internal thread 

Availability:
Quantity:

Laser Gas Analyzer Introduction

Laser gas analyzer is for gas measurement, developed based on tunable diode laser absorption spectroscopy. One-side mounting installation is much easier than cross-stack. By using a tunable semiconductor laser,  laser gas analyzer scans the specific absorption lines of the measured gas(no background gas) to get the second harmonic of the gas. Through processing and analyzing the second harmonic and the broadening information of the gas, the concentration of the gas is obtained.

Oxygen analyzers provide valuable measurements in combustion control, process quality, safety and environmental applications. These are used in a variety of measurement scenarios including, but not limited to, boiler trimming in power plants, furnace optimization in refinery and petrochemical applications, process safety in vent headers, and product quality in ethylene production.

Laser Gas Analyzer Feature

  • Non-contact optical measurement, low drift and with long service life.

  • One-side installation, no complex adjustment  of optical path required.

  • Reference gas cell adopted; online calibration; no disassemble needed

  • 'SIngle line spectrum' technology, free from interference of background gas

  • In-situ measurement, no sample conditioning required and avoiding the problems that sample is absorbed during conditioning process, blocking, unit damage and etc.

  • Low maintenance cost


Laser Gas Analyzer Specification 


Technical Index


Linearity Error: ≤  ±1%F.S.

Repeatability: ≤ 1%

Span Drift: ≤ ±1%F.S./halfyear

Zero Drift: ≤ ±1%F.S./half year

Maintenance Cycle: ≤ 2 times/year (clean optical window)

Calibration Cycle: ≤ 2 times/year

Response Time(T90): ≤ 1s

Signal I/O:


Analog Output: 2 x 4-20mA output (isolation, max load 750 Q )

Analog Input: 2 x 4-20mA input (temperature and pressure compensation )

Relay Output: 2 (24V,  1A)

Digital Output: RS485/RS232/GPRS

Work Condition:


Power Supply: 24VDC or 220VAC

Ambient Temperature: -20 °C ~ +60 °C

Purge Gas: 0.3MPa - 0.8MPa industrial nitrogen, purification instrument air, etc.

Installation:


Installation Method: In situ installation

-Manuals

Laser Gas Analyzer

-Data sheet


Laser Gas Analyzer Application

Apply to converter gas recovery gas analysis, CDQ circulating gas analysis; oxygen measuring electric fishing coke oven gas after analysis; pulverized coal injection gas analysis; ammonia escaping gas analysis in the cement industry; trace CO detection and analysis electricity, cement, environmental protection; HCl and HF trace analysis in environmental protection and  chemical industry


Previous: 
Next: