+86-182-9191-0663 丨  sales@hiltechgroup.com | support@hiltechgroup.com

About Us

Since 1998 丨 HILTECH®

You are here: Home » News » News » Fisher dvc6000 valve positioner installation instructions

Fisher dvc6000 valve positioner installation instructions

Views: 1     Author: Site Editor     Publish Time: 2021-09-23      Origin: Site

Installation and basic setup steps


Install


Instrument installation


1. Install the positioner on the actuator correctly.


2. Connect the feedback mechanism correctly.


Gas connection and gas supply


1. Install the pressure reducing valve correctly.


2. Connect the air source and set the air pressure correctly.


3.Connect the meter output to the actuator.


2.Fisher-dvc6000-valve-positioner-installation-instructions

Electrical connections


1. If necessary, install threaded pipes and hoses correctly.


2. Correctly connect the return wire to the return + and-terminals in the junction box.


Basic setup and verification


1. Complete the basic settings.


2. Complete verification.


3. The final control unit (control valve) correctly responds to the change of the set point and works stably. If necessary, stabilize or optimize the valve response.


The final control unit (control valve) can be put into online operation after debugging.


Menu structure of Model 275 HART communicator for FIELDVUE DVC6000 



1-2-7-2-3 Zero Control Signal


Install 67CFRF filter regulator


There are three installation methods for 67CFRF filter regulator and DVC6000 series digital valve controller.


See Figure 1 for an integrated voltage regulator. Apply lubricant to the O-ring and place it on the air supply connection port on the digital valve controller


In the counterbore, install the 67CFRF filter regulator on the side of the digital valve controller with a 1/4 inch hexagon socket plug


Block the unused output ports on the filter regulator. This is the standard method of assembling the filter regulator.