ADMAG SE is the Safe and Easy magnetic flow meter which makes your job simple and effective. You will increase the productivity and profitability. The installation, operation, and maintenance are all safe and easy.
ADMAG SE is equipped with a dual compartment housing providing ease of wiring while isolating the electronics from the environment. It is also prepared with HART or BRAIN communication as standard and its light weight makes installation easy.
High Reliability
Based on Field Proven Technology
Proven Construction
Long Term Durability
Compliance to World Market Requirements
General Safety
CE mark, C -Tick mark
Explosion Proof
ISO Standard
High Accuracy (0.5% of flow rate)
Easy Operation and Maintenance
Parameter Setting with Touch Control
Self Diagnostics
Light Weight and Easy Installation
Face to Face Length conform to ISO Standard (Flange Type)
Easily Visible Display
The Large Visible LCD Panel
Communication Capability
HART or BRAIN as standard
Cost-effective
Note : HART is a registered trademark of the HART Communication Foundation .
Diameter: 15, 25, 40, 50, 80, 100, 150, 200 mm
· Excitation mode: Pulse DC excitation
· Lining: PFA or FEP
· Conductivity: 5 μs / cm
· Velocity range: 0 ~10 m/ s
· Accuracy: ±0.5% of the indicated value
· Repeatability: 0.2% of indicated value
· Medium temperature:-10 ~ +130 ℃
· Ambient temperature:-20 ~ +60 ℃
· Power supply voltage: 220 VAC
· Fluid pressure:-0.1 ~ 4.0 Mpa
Output signal: analog 4 ~ 20 mA, pulse, alarm
· Communication: (optional) BRAIN communication
· Power consumption: 10 W (including sensor and converter)
· Can provide general type and explosion-proof type
Basic performance index
· Accuracy: ±0.5%
· Power consumption: 10 W (including sensor and converter)
· Insulation resistance: At 500 V DC, the insulation resistance between the power supply and the ground terminal is 100 MΩ.
· At 500 V DC, the insulation resistance between the power supply and each output terminal is 100 MΩ.
· Insulation strength: 1500 V AC (1 minute resistance between power and ground)
Standards required for safety: IEC 1010, EN61010
1. Divided by size: 2600~2.5mm in diameter, and can be designed and manufactured according to customer requirements. Can meet the special requirements of customers.
2. Distinguish by connection mode: flange connection type and clamping type.
3. According to the converter: there are integrated type and separate type.
4. Distinguish by special purpose: diving type and flameproof intrinsically safe type, etc.
-Manuals
Yokogawa ADMAG SE Series Magnetic Flow Meters
-Data sheet