Submersible pumps are installed completely underwater, motor and all. They tend to operate with greater efficiency as they are constructed with either dry motors, where water cannot get into it, or with wet motors where the motor functions normally despite water running through. Our submersible pumps are designed for irrigation applications, with a streamlined, space-saving design,
Double working capacity compared to other pump sets
Corrosion resistant SS 304 stage casing SS 410 impeller increases the life of pump
Helps to lift water from higher depth with reduced number of stages.
Carbon Teflon pads are used to withstand the up thrust load.
Specially designed Thrust Bearings to withstand high axial thrust loads
High operating efficiency and consistent performance ensures low operation cost
Motor is designed with higher cooling effect by increasing the housing areas.
Power Range | 2.2 kW - 22 kW (3 HP - 25 HP) |
Voltage Range | 3Ph - 380 - 415V, AC Supply |
Maximum Total Head | 500 Metre |
Maximum Flow Rate | 20 lps (72 m3/hr) |
Suction Housing | Cast Iron with SS 410 Top Plate |
Impeller | SS 410 |
Pump Shaft | SS - 410 |
Motor Base | Cast iron |
-Manuals
Irrigation Submersible Water Pumps
-Data sheet
Submersible Irrigation Pumps Submersible pumps are used for lifting water from well, they are widely used in agricultural and high altitude area irrigation. So they are suitable to be used in plain area with small amount of water.